Spinning Report

I have been spinning regularly, every day, when possible.  I typically spin in the mornings, and usually for 30 minutes to an hour.  I find it very meditative, and it sets my brain (and mood) up nicely for the rest of the day.  Since my last spinning post on March 7, I have spun and plied over 800 grams of yarn.  All of these yarns were spun on my Kromski at a 12:1 ratio and plied on my Kiwi at a 9.5:1 ratio.

This is my 10th skein.  I went back to the Heinz 57, which I use as a sort of pallet cleanser, and a way to reset myself after spinning a new base.  This skein came in at 135 yards and 86.4 g, or 1.56 yd/g and about 10 wraps per inch, so something between a worsted and a DK.  I dyed the skein with Plum from Wool Tincture Dyes.  I still have some variation in the dye take up, mostly where the ties are, even though I do try to tie loosely and I swish the fiber around in my dye jar.  I’m not overly concerned, as I’m not going for total uniformity.  Here is a picture of the skein untwisted.

Overall I am happy with both the singles consistency - there is not as much variation as I’ve had in the past, and the plying consistency.  I do like the set up I have with spinning on the Kromski and plying on the Kiwi.  I’m not sure what I will make with this yarn, but have been thinking about some fingerless mitts.

A little while ago I did an impulse buy of some of Rosie’s Multicolor Merino Tops from The Woolery, so I tackled them next and focused on my singles, trying to be consistent.  For each of the tops I used the same process:  I took the 250 g top out of the bag and shook it out, and then divided it into three equal sections length-wise.  Two of the sections I wrapped up in to a nest and set aside, then I took one section and divided it in half length-wise again, so that I had two pieces of top that were about the same length.  I then stripped the top in half, and then in half again, so I was working with about one quarter of the top at a time to keep the colors from blending too much.  All were spun using short forward draw and scotch tension.  I spun two bobbins from each of the three original sections of top, I wound the bobbins off the wheel and onto another bobbin and let them sit overnight (at a minimum) before plying.  I did not spin up all of the fiber and then mix the bobbins, which I know is recommended to minimize variations in the plied yarn by compensating for variations in the singles, but I wanted to see my inconsistency, not mask it.  I spun a section, and plied it, and then spun the next section and plied it, until I had spun and plied all three sections.

The first top that I grabbed was the Cornucopia colorway.

From left to right these are skeins 11a, 11b, 11c, and 11d.  As I settled in to spinning this top my singles settled in to a slightly thicker diameter.  When I was plying the first two bobbins I had a break, which I didn’t fix, so I ended up with two smaller skeins.

Skein 11a came in at 49 yards and 26.5 g, or 1.84 yd/g

Skein 11b came in at 76 yards and 44.5 g, or 1.69 yd/g

Skein 11c came in at 145 yards and 89.7 g or 1.62 yd/g

Skein 11d came in at 130 yards and 89.8 g or 1.44 yd/g

Next I grabbed the Valentine colorway.

From left to right these are skeins 12a, 12b, and 12c.  The singles on these three skeins are far more consistent.

Skein 12a came in at 115 yards and 79 g, or 1.46 yd/g

Skein 12b came in at 111 yards and 79.6 g, or 1.4 yd/g

Skein 12c came in at 121 yards and 84.3 g, or 1.44 yd/g

The last top is the Purple Haze colorway.

From left to right these are skeins 13a, 13b, and 13c, and on these skeins I went back to a thinner single, even thinner than what I had achieved on the first colorway.  I wanted to see how thin I could comfortably and consistently spin on the 12:1 ratio whorl.

Skein 13a came in at 154 yards and 78.1 g, or 1.97 yd/g

Skein 13b came in at 176 yards and 82.5 g, or 2.13 yd/g

Skein 13c came in at 161 yards and 83.6 g, or 1.93 yd/g

Overall, I am very happy with my spinning and plying on all of these skeins, and with the greater consistency I am achieving.  Although I have no idea what I want to make out of these three sets.

After finishing up these three tops I decided to go down a whorl size, so I set up with my 16:1 whorl and started spinning some more Heinz 57 top.  I haven’t finished my first bobbin yet, but I do have two ply-back samples:

After looking at the first ply-back sample (top) I decided I needed a bit more twist in my singles, which you can see in the bottom ply-back sample.  I’m pretty chuffed with the fineness I am achieving.  These are still short forward draw, although I did do a few inches of long draw just to see how it felt and looked - and it felt and looked pretty good.  Once I have spun short forward draw on all of my Kromski whorls (after the 16:1, I will do the 20:1), I will go back to the biggest whorl and practice long draw on all of them.